1.

The most important thing to remember about speed management and curves is that you must:

Drive at the posted speed limit as you enter the curve, then slow down at the sharpest part of the curve.
Slow down before you enter the curve.
Accelerate gently before you enter the curve.
Drive at the posted speed limit before, throughout, and after the curve.

2.

Look over your shoulder to check your blind spot when:

Pulling toward or away from a curb.
Turning left or right.
Changing lanes.
All of the above.

3.

You notice a vehicle defect which may affect the safe operation of your vehicle. You should:

Correct the defect as soon as possible.
Correct the defect when you can afford it.
Drive the vehicle at slower speeds.
Drive normally.

4.

What should you be most concerned about when you see this sign?

Driving with your headlights out of alignment because one side of your car is higher than the other.
Damaging a tire from drifting onto the shoulder.
Hydroplaning, if the shoulder has water on it.
Losing control of the vehicle if you drift onto the shoulder.

5.

When a school bus is stopped off the road without flashing lights, you should:

Stop until the bus moves on, regardless of which side of the road you’re on.
Stop until the bus driver signals for you to go.
Stop only if you’re on the same side of the road as the bus.
Use caution as you pass the bus, since you’re not required to stop.

6.

When approaching an uncontrolled intersection, a driver should:

Maintain their speed and proceed.
Stop at the intersection, check in all directions, and proceed.
Yield to all other drivers.
Be prepared to yield.

Washington Driving Test Online 2020

Wait, before you go