Ohio Motorcycle Permit Test

If the throttle becomes stuck and you are unable to free it, immediately operate the engine cut-off switch and pull in the clutch at the same time. This will remove power from the rear wheel until you are able to safely leave the road and stop.

Compared to a car, a motorcycle requires more frequent attention. If something is wrong with a motorcycle, it is essential that the operator identify the problem before getting into traffic or operating the bike at freeway speeds.

Warning signs are yellow with black lettering or symbols and provide important information to motorists about upcoming road conditions. This sign warns that a stop sign is ahead.

Regulatory signs are white signs with red and black markings that inform drivers of specific traffic laws in the indicated area. This sign indicates that right turns are prohibited.

Make sure your motorcycle's transmission is in neutral before you start the engine. Most motorcycles have a neutral indicator on the speedometer that lights up when the ignition switch is on and the cycle is in neutral.

To swerve away from a hazard, apply a small amount of pressure to the handgrip located on the side of your intended escape.

Perform an inspection of your motorcycle before every ride. This takes only a few minutes and helps prevent dangerous situations before entering traffic.

As you approach an intersection, select a lane position that will make you the most visible to other drivers and cover the clutch and both brakes to reduce your reaction time. Reduce your speed when approaching an intersection. Avoid changing your speed or position radically as doing so may cause surrounding drivers to misinterpret your intentions.