New York CDL Permit Test - Class A

Number of questions: 50
Passing score: 40
Directions: This license is required for driving any legal combination of vehicles, with a gross combination weight rating of 26,001 pounds or more, provided the GVWR of a trailer exceeds 10,000 pounds. To receive this license, applicants must pass a 70-question test. Test questions come from the New York State Commercial Motor Vehicle Drivers Handbook. Each question has four answer choices. To pass, applicants must answer 56 questions correctly. Questions come from chapters covering: Introduction, Driving Safely, Transporting Cargo Safely, Air Brakes (if applicable), Combination Vehicles, Pre-Trip Vehicle Inspection Test, Basic Vehicle Control Skills Test and On-Road Driving. Endorsements that may be used with a Class A CDL are: Hazardous materials, Tank, Passenger, Doubles/Triples, HazMat, Tank, Air Brakes and School bus.
You have made error so far
Passing grade —
10 or fewer errors
advertising
1.
Which of the following conditions may require a truck to have a Gross Vehicle Weight (GVW) that is below the legal maximum GVW?
A flat road
A mountainous road
Heavy traffic
Night driving
2.
If you are unsure if there is enough space for your vehicle to go under a bridge, you should:
Speed up
Swerve as you pass under the bridge
Slow down
Drive on the shoulder
3.
When checking your vehicle's lights before driving:
The vehicle should be running and in gear.
The engine should be turned off.
The check can be done from inside the vehicle.
The check can be done by looking at a reflection from a shiny surface.
4.
When carrying a sealed load:
The driver should inspect the contents
The driver should ensure the weight does not violate weight limits
The driver must go through the container
The driver should unseal the load to ensure safety
5.
Without engine oil:
The vehicle will get better gas mileage
The engine can be destroyed quickly
The ABS won’t work properly
The windshield wipers will not operate
6.
When operating a vehicle with a dual brake system, a driver should:
Let the vehicle warm up before driving to ensure that fuel reaches the engine.
Wait to begin driving until the air compressor builds up a minimum pressure of 100 psi in both the primary and secondary systems.
Begin driving just after the vehicle starts.
Pump the pedal about 20 times to build pressure, then begin driving.
7.
All air tanks must include:
A check valve.
A lock.
A trap door.
A warning sticker.
Rate this test
4.2 out of 5
based on 98 votes
Our Latest Videos