Instructions

Combination

All applicants who are applying for a Class A CDL should be prepared to take the Combination test. This test covers information found in Section 6 of the Commercial.. Read More

All applicants who are applying for a Class A CDL should be prepared to take the Combination test. This test covers information found in Section 6 of the Commercial Driver's Manual. Section 6 provides the information needed to safely operate tractor-trailers, doubles, triples, and straight trucks with trailers. The test is made up of 20 multiple-choice questions, and applicants will need to correctly answer a minimum of 16 questions to pass. The Combination test is not a replacement for the Double/Triple endorsement test.

Number of Question 20

Passing Score 16

8. Rollovers happen when:

A truck driver is driving too fast.

The driver of a vehicle in front of a truck is moving to slowly.

A truck driver is driving too slowly.

ABS is working effectively.

Rollovers happen when a vehicle is driven too fast. To reduce the risk of rollover, make sure the weight of cargo is loaded low to the ground, and that you take turns and curves slowly.

9. Fully-loaded rigs:

Are less likely to roll over than empty rigs.

Are more likely to roll over than empty rigs.

Are just as likely to roll over as empty rigs.

Should not be driven.

Because the weight of cargo gives them a higher center of gravity, fully-loaded rigs are 10 times more likely to roll over in a crash than empty rigs.

10. Air pressure in the ____ air line is controlled by either the foot brake or trailer hand brake.

Emergency

Service

Rear

Auxiliary

Air pressure in the service air line is controlled by either the foot brake or trailer hand brake. The service air line is also known as the control line or signal line. This line is connected to relay valves, which allow the trailer brakes to be applied more quickly than would otherwise be possible.

11. A lightly-loaded combination vehicle will stop more slowly than a fully-loaded vehicle because:

The stiff suspension springs and strong brakes will have high traction.

The stiff suspension springs and strong brakes will have low traction.

The brakes only operate when a trailer reaches a minimum weight.

The suspension springs only operate when a trailer reaches a minimum weight.

An empty combination vehicle will come to a complete stop more slowly than a fully-loaded vehicle. The stiff suspension springs and strong brakes will have lower traction on a light trailer than they would if the vehicle carried more weight.

12. Trailers with low underneath clearance may be difficult to drive:

On interstate highways.

Over railroad crossings.

On dirt roads.

At the posted speed limit.

Railroad-highway crossings may be difficult to cross when pulling a trailer with a low underneath clearance. In particular, both low-slung units and single-axle tractors pulling long trailers are especially challenging to drive over raised crossings.

13. A shut-off valve:

Is located on the front of a trailer.

Is located on the instrument panel.

Prevents air from escaping an air brake system.

Should always be open.

Shut-off valves are used in air supply lines to control the passage of air from one trailer to another. The rear shut-off valve should always be closed to prevent air from leaving the braking system.

14. A combination vehicle has:

One air line.

Two air lines.

Three air lines.

Four air lines.

Combination vehicles have two air lines: a service line and an emergency line.

Grade This Section

See the exact questions that will be on the 2025 Pennsylvania DMV exam.

99.2% of people who use the cheat sheet pass the FIRST TIME

Alexa shares with us how she went in for her Class A permit and decided to get her Hazmat endorsement as a bonus!

Mark shares his feedback on his Class A CDL Cheat Sheet

Click Here
Full Cheat Sheet Unlock Your Exclusive Cheat Sheet!