Oklahoma CDL Permit Test - Bus

School bus drivers may only pick up students at official stops designated by authorized school officials.

When stopped at a railroad crossing while operating a school bus, do not rely only on signals to tell you if a train is approaching. You should silence all passengers, open the front door, and look and listen for trains. After a train has passed, you should check for another train approaching from either direction before you proceed across the tracks.

Properly adjusted crossover mirrors on a school bus should allow the driver to see the entire area in front of the bus, from the front bumper at ground level to a point where direct vision is possible. The mirrors should also display the right and left front tires touching the ground, as well as the area from the front of the bus to the service door.

You should finish each exercise with your vehicle in the exact position described by the examiner. You can be penalized for failing to complete an exercise exactly in the manner described by the examiner, potentially resulting in failure of the basic control skills test.

You may be asked to complete a conventional parallel parking maneuver into a parking space that is to the right of your vehicle. You should drive past the parking space before backing into it while bringing the rear of your vehicle as close to the rear of the space as possible. Your vehicle should be completely within the boundaries of the space.

While students are boarding a school bus, the driver should supervise the loading while watching all mirrors for any students running to catch the bus.

During the pre-trip vehicle inspection test, you will be asked to indicate where the dipstick is located. You will need to show that the oil level is within a safe operating range and above the refill mark.