Ace Your DMV Written Test with our Guaranteed Cheat Sheet.
Cheat Sheet

Mississippi driver's examination

Number of tests: 24
Number of questions: 30
Passing score: 24
Directions: The Mississipi written examination tests your knowledge of traffic laws, road signs, and driving safety rules. It determines whether you are prepared to operate a vehicle in accordance with Mississipi law.

The knowledge test consists of 30 multiple choice questions that are important to the safe operation of a motor vehicle and Mississipi laws and driving practices. The questions are based on the information provided in the manual.

A passing score consist of at least 24 correct answers.

If you fail the test, you cannot repeat it the same day. If you should fail to pass the examination after three attempts, you must wait thirty 30 days to take it again.
You have made error so far
Passing grade —
6 or fewer errors
advertising
1.
In traffic moving at 50 to 55 mph, you are least likely to have an accident if you:
Drive a few miles per hour faster than most other vehicles.
Stay within that speed range.
Drive a few miles per hour slower than most other vehicles.
2.
A solid yellow line next to a broken yellow line means that vehicles:
Driving in both directions may pass.
Next to the broken line may pass.
Next to the solid line may pass.
3.
When a school bus is stopped ahead on your side of the road with its red lights flashing, you must:
Slow to a speed no faster than 10 mph.
Stop until the lights stop flashing.
Change lanes and pass cautiously.
4.
The driver ahead of you stops at a crosswalk. What should you do?
Cautiously pass the vehicle at 10 mph or slower.
Stop, proceeding only when all the pedestrians have crossed.
Change lanes, look carefully, and pass the stopped vehicle.
5.
When approaching an intersection with a flashing red light, drivers should:
Come to a complete stop before proceeding.
Proceed, as they have the right-of-way.
Slow down but continue through the intersection without stopping.
6.
When driving in fog, rain, or snow, use:
Low beams.
High beams.
Fog lights only.
7.
Broken yellow lines are used on streets and highways to:
Indicate no passing zones.
Separate lanes of traffic moving in the same direction.
Separate lanes of traffic moving in opposite directions.
8.
When a gate at a railroad crossing is lowering, you should:
Speed up and cross the tracks before the gate lowers completely.
Come to a complete stop and wait.
Drive around the gate.
Rate this test
4.8 out of 5
based on 25 votes
Our Latest Videos
Ace Your DMV Written Test
Get your Cheat Sheet Now!

Wait, before you go

Ace your DMV Written Test with our Guaranteed Cheat Sheet.

  • Cheat Sheets Save Time
  • Cheat Sheets pass on your first try